Well I have been all over ultimarc webside reading faq trouble shooting guids and ohming out connections.
I started w ground all check out, then all switches the are all connected properly and ohm out to verify. All buttons and sticks are brand new. Firmware is what came with it 1.34
I program switch 3 to be e and switch 4 to be t
It says its programmed successful then when i test switch 3 with that keyboard tester suggested off ultimarcs site it presses e and t simoltaniously???????? Is this normal ???? And the buton for switch 4 does nothing ??????
Even if i disconnect everything then program it using a small piece of wire quickly connwct sw 2 (one that works) and it types the assigned character in the tester app. When i do the same to sw 3 pin same deal it types e and t. I even tried to make them different letters and they wont change. Its weird. Anyone else seen this like. It may be the board or the software to program it. I am using win 10. I tried all the steps. Reset usb by removing it and re adding it. Im out of ideas and i suspect the board is not properly wring the value from the buffer or in win 10 its not working right.
Anyone else successful in programming / assigning keys ????
Anyone else using win 10 to do so.
I tried also running as admin no change and runnong in qin 7 compatability mode also as admin same thing. This is getting frustrating.
|