I found these hlsl settings on a forum and i use it on MK2 only things i adjusted was brightness/contrast/gamma & scanline darkness with the artwork
# DIRECT3D POST-PROCESSING OPTIONS # hlsl_enable 1 hlslpath hlsl hlsl_ini_read 0 hlsl_ini_write 0 hlslini %g hlsl_prescale_x 3 hlsl_prescale_y 3 hlsl_preset -1 hlsl_write hlsl_snap_width 2048 hlsl_snap_height 1536 shadow_mask_alpha 0.200000 shadow_mask_texture aperture.png shadow_mask_x_count 320 shadow_mask_y_count 240 shadow_mask_usize 0.09375 shadow_mask_vsize 0.109375 curvature 0.000000 pincushion 0.050000 scanline_alpha 1.000000 scanline_size 1.000000 scanline_height 1.000000 scanline_bright_scale 1.000000 scanline_bright_offset 0.600000 scanline_jitter 0.000000 defocus 0.000000,0.000000 converge_x -0.100000,0.000000,0.100000 converge_y 0.100000,0.000000,-0.100000 radial_converge_x 1.300000,0.000000,-1.300000 radial_converge_y -0.300000,0.000000,0.300000 red_ratio 1.000000,0.000000,0.000000 grn_ratio 0.000000,1.000000,0.000000 blu_ratio 0.000000,0.000000,1.000000 saturation 1.000000 offset 0.000000,0.000000,0.000000 scale 1.000000,1.000000,1.000000 power 1.000000,1.000000,1.000000 floor 0.000000,0.000000,0.000000 phosphor_life 0.200000,0.200000,0.200000
# # NTSC POST-PROCESSING OPTIONS # yiq_enable 0 yiq_cc 3.59754545 yiq_a 0.5 yiq_b 0.5 yiq_o 1.570796325 yiq_p 1.0 yiq_n 1.0 yiq_w 4.1887902047863909846168578443727 yiq_y 6.0 yiq_i 1.2 yiq_q 0.6 yiq_fsc 1.5 yiq_fsc_scale 0.5 yiq_scan_time 52.6 yiq_phase_count 2
|