A couple years ago I purchased two Aimtrak light guns and I think they worked for about a day. Right after that my Mame machine went down and I figured I would get them working when I got the machine back up. Two years or so later I got around to getting it to work and now am trying the guns. I found that it will not calibrate. So I used the utility to find that I have a good ir signal at about 2 inches from the sensor past that it's yellow. I have a laptop and a hp thin client and they work the same so I figured they are not getting enough power from the portable devices. So, I got a powered usb hub and found that the sensor bar never lights up the port on the hub. I tried different ports and I know the lights work. The gun kind of works.... but sporadically and is never able to finish a calibration. Anyone have any ideas? I am pretty disappointed as I bought two guns for over a hundred dollars and never got any use out of them.
Edited by schlechtj (09/06/16 07:37 AM)
|
Previous 
Index 
Next 
Flat 
Aimtrak problem
Reply
