Entrance | Main Index | Search | New user | Login | Who's Online | FAQ | Rules

Frontend Tech + >> Ultimarc
Previous thread Previous  View all threads Index   Next thread Next   Flat Mode Flat  

Pod
MAME Fan
Reged: 11/14/11
Posts: 9
Send PM
Re: Losing v-Sync when using J-pac
04/13/16 08:35 AM
Reply to this post Reply


A hantarex 9110. When I say direct connection what I mean is I've spliced the wires near the monitor and attached a vga cable. This is how I used to run it back when I had an arcade vga before I upgraded to the ati 4xxx and jpac combo.
However I can't exactly tell you what wire went where as it was so long ago. I followed a guide on arcade controls or possibly the one on ultimarcs site. Quite likely I've combined h and v sync together as Andy suggests

Perhaps the jpac does something else other than just boost the signal? But as mentioned if I run it via the jpac and choose any non-interlaced mode it's perfectly fine.

Paul

Edited by Pod (04/13/16 08:53 AM)






Entire thread
Subject Posted by Posted on
* Losing v-Sync when using J-pac Pod 04/12/16 09:14 PM
. * Re: Losing v-Sync when using J-pac krick  04/13/16 04:03 AM
. * Re: Losing v-Sync when using J-pac Traso  04/12/16 10:58 PM
. * Re: Losing v-Sync when using J-pac Pod  04/13/16 08:35 AM
. * Re: Losing v-Sync when using J-pac Traso  04/17/16 09:00 AM

Extra information Permissions
Moderator:  Andy Warne 
0 registered and 13 anonymous users are browsing this forum. 		You cannot start new topics
You cannot reply to topics
HTML is enabled
UBBCode is enabled
Thread views: 3006


Browser Test | Delete Cookies atom-guru atom-guru *
UBB.threads™ 6.3.2