>If the spintrac is working correctly, even just on the desktop, the mouse cursor should move along the x-axis, right?
>Not doing it.
Yes it should.
>In MAME I have mouse input enabled & nothing working there either.
>It's getting power from the IPAC Ultimate & into the base of the spinner but nothing is working. I've read about people having to re-wire the connections. I wanted to get some opinions before I started stripping wires & such...
>(It's a 4 pin flat connector, I'm getting +5v from the 2nd pin & the 4th is the ground. The 1st & 3rd should be the axis but that's not what the diagrams say it should be...?)
Correct^^^
>Any other ideas?
>Thanks for any help
FIXED: The spinner itself was bad. Andy sent me a new 1 & it works perfectly. Just an odd occurrence to get a bad part. Happy now... 
Pessimist: Oh, this can't get any worse!
Optimist: Yes, it can!
Edited by Bad A Billy (05/08/16 05:01 AM)
|
Previous 
Index 
Next 
Flat 
Spintrac question...UPDATED - Fixed
Reply
