Thanks for the info, chaps.
I run all my games at 1920x1080 to keep the artwork looking nice and give HLSL room to play. I just wanted to run each game at it's native refresh rate (or near as damn it) to keep the game at it's proper speed - I run with vsync on and throttle off, for smooth scrolling.
I did this by specifying the Hz in the cfg for games with non-60Hz refreshes. The problem was that MAME stays in that mode when exiting a game and launching another that doesn't have a cfg that specifies the Hz to use.
I kludged the issue by writing a little prog that makes a cfg for every game, setting Hz to 60. I then just edited the files for games that use a non-60Hz refresh.
On a related issue, is it possible to specify an interlaced mode? I tried "resolution 1920x1080@60i" but it didn't work.
[edit] I mean ini files, not cfg. 
Edited by big10p (06/24/14 01:38 PM)
|
Index 
Flat 
Re: MAME command line param to list game info?
Reply
