> > How do config controls in Roads Edge? Service mode is not mapped and i dont know
> how
> > to enter through the debugger.
> >
> > Thanks.
>
> Ok, follow these steps:
>
> Debugger activated, press F5 and wait after the network check goes over. Enter into a
> Memory Dump (CTRL+M), go into options and change visualization to Physical Address
> (CTRL+Y). Enter "0xa2363" (for Xrally) or 0xcfb53 (for Roads Edge) into Text Field
> (of course press Enter). Finally, change the aforementioned RAM address to a 1 in the
> Hex dump and finally press F12 to run service mode.
>
> Of course I need to understand where it takes that 1, and, even better, I need to
> understand why 3d is so screwed ...
are there any chances that this method,or a similar one,involving debugging,could finally start the game "panic park" properly?
|
Index 
Flat 
Re: Kale: Burrito Uan
Reply
