Ok. So I've made a circuit which adapts NES/SNES controllers to JAMMA. Now, I was testing the NES pad fine, let my chara die to end the game and then changed over the NES controller for the SNES (nothing really changed, same format, just different controller). I wanted to go into the test menu to make sure all buttons worked and so pressed the test button and for some reason I got a much longer test menu than usual. In it I had options to change the harddisk transfer mode from DMA/PIO, whether it should report disk read errors during game, the actual port addresses of the button states and other good ness.
Now, try as I might I can't seem to get back into this menu. I know it's not the controller that caused it but I can't figure out what I did or what key combo I did to get into such menu.
Any one heard about this? Know the code?
----
On a quest for Digital 573 and Dancing Stage EuroMix 2
By gods I've found it!
|
Index 
Flat 
Debug mode on Gauntlet DL?
Reply
