MAMEWorld >> Hardware
Previous thread Previous  View all threads Index   Next thread Next   Flat Mode Flat  

italieAdministrator
MAME owes italie many thank yous, hah
Reged: 09/20/03
Posts: 15246
Loc: BoomTown
Send PM
Re: NOOB Needs a little advice/support
03/15/11 01:44 AM


> I took the boards out today and reseated all the chips i could. Still the same. Not
> sure which is the ram but i read somewhere it is quite difficult to tell if its
> faulty. Seeing as it is cheap, it may not hurt to replace it anyway, just is though I
> don't know which my board takes.

How was your +5 voltage? Measure it at the board if possible, be sure it's around 5-5.2V







Entire thread
Subject Posted by Posted on
* NOOB Needs a little advice/support weedsmacker 03/06/11 11:47 PM
. * Re: NOOB Needs a little advice/support italieAdministrator  03/07/11 12:24 AM
. * Re: NOOB Needs a little advice/support weedsmacker  03/09/11 01:39 AM
. * Re: NOOB Needs a little advice/support weedsmacker  03/10/11 01:51 AM
. * Re: NOOB Needs a little advice/support italieAdministrator  03/10/11 03:25 AM
. * Re: NOOB Needs a little advice/support weedsmacker  03/11/11 01:42 AM
. * Re: NOOB Needs a little advice/support weedsmacker  03/11/11 01:52 AM
. * Re: NOOB Needs a little advice/support italieAdministrator  03/11/11 03:18 AM
. * Re: NOOB Needs a little advice/support weedsmacker  03/12/11 04:25 AM
. * Re: NOOB Needs a little advice/support weedsmacker  03/13/11 08:38 PM
. * Re: NOOB Needs a little advice/support italieAdministrator  03/14/11 03:24 AM
. * Re: NOOB Needs a little advice/support weedsmacker  03/15/11 01:23 AM
. * Re: NOOB Needs a little advice/support italieAdministrator  03/15/11 01:44 AM
. * Re: NOOB Needs a little advice/support weedsmacker  03/16/11 12:09 AM
. * Re: NOOB Needs a little advice/support weedsmacker  03/17/11 01:07 AM

Extra information Permissions
Moderator:  GatKong 
0 registered and 33 anonymous users are browsing this forum.
You cannot start new topics
You cannot reply to topics
HTML is enabled
UBBCode is enabled
Thread views: 3413