italie |
|
MAME owes italie many thank yous, hah
|
|
|
|
|
|
Reged: 09/20/03
|
|
Posts: 15245
|
|
Loc: BoomTown
|
|
|
|
Send PM
|
|
Re: NOOB Needs a little advice/support
03/14/11 03:24 AM
|
|
|
> OK,,update,,I went today to see if I could investigate the coin operation, but when I
> turned on, I noticed a loud hissing from the anode. I discharged the monitor, removed
> the cap and noticed the cup was damaged. I replaced with one from an old monitor I
> had, booted up and this is the screen that keeps coming up now. NOTE: this is the
> screen that come up before I discharged and replaced the cap. Could this be a board
> issue rather than a monitor issue?
I would say board issue, either a bad/mis-seated RAM, a bad/mis-seated EEPROM, or your voltages are a little low. Could be other thins to, but those are the usual culprits to check first.
If those boards have ribbon cables, make sure they are secure as well.
|
|
Previous 
Index 
Next 
Flat 
Re: NOOB Needs a little advice/support
Reply
Re: NOOB Needs a little advice/support
