Good morning all !
I have a problem with the HLSL settings. The HLSL options in Slider Controls are not the same as in the MAME.ini file ???
Here are my settings:
Here is the content of the MAME.ini file:
Code:
# DIRECT3D POST-PROCESSING OPTIONS
#
hlslpath hlsl
hlsl_enable 1
hlsl_oversampling 0
hlsl_write auto
hlsl_snap_width 2048
hlsl_snap_height 1536
shadow_mask_tile_mode 0
shadow_mask_alpha 0.0
shadow_mask_texture shadow-mask.png
shadow_mask_x_count 6
shadow_mask_y_count 4
shadow_mask_usize 0.1875
shadow_mask_vsize 0.25
shadow_mask_uoffset 0.0
shadow_mask_voffset 0.0
distortion 0.0
cubic_distortion 0.2
distort_corner 0.0
round_corner 0.1
smooth_border 0.0
reflection 0.5
vignetting 0.5
scanline_alpha 0.0
scanline_size 1.0
scanline_height 1.0
scanline_variation 1.0
scanline_bright_scale 1.0
scanline_bright_offset 0.0
scanline_jitter 0.0
hum_bar_alpha 0.2
defocus 0.0,0.0
These are not the same parameters & when launching MAME I have to configure everything again, why? How do I save my settings permanently ?
Thanks best regards !
Edited by Sebiohazard (01/26/20 07:14 PM)
|
Previous 
Index 
Next 
Flat 
The HLSL parameters are not saved why ?!
Reply
Re: The HLSL parameters are not saved why ?!
