> When you change the control in "Input (This Machine)" does it show a keyboard
> character or joystick up/down/right/left?
> Same for the buttons, Button A,B,C,D or ctrl, alt, space or ????
>
> Since Windows is seeing them as USB Generic Joysticks MAME is probably getting those
> winID's for the controllers & that will change each time you run MAME, thus you have
> to re-do them everytime. I've never had to deal with that but I think there is a
> semi-workaround in the forum here somewhere.
>
> Or it could be something completely different with what seem to be your odd i-pac
> decoded joysticks(?)...If it was an i-pac decoder it should say USB HID Device not a
> generic joystick & show key presses, not directions or button presses.
> Something odd going on with those for sure so I could be completely wrong & someone
> will correct my assumptions.
Yes it shows the controls, as i said earlier the controls are actually sadev, as in, they are "visible" in the input menu. they are just not saved "for real", unless i do that manually at least once on the "input this machine". after that they stay saved. but then again, on non-ui mame it just worked the first time around on "input general"
|
Index 
Flat 
Re: Controls set in "Input General" are not saved. Saved fine in "input this machine"
Reply
Re: Controls set in "Input General" are not saved. Saved fine in "input this machine"
