> That's the problem. I'm not sure how to reprogram the MAME controls. When the cabinet
> was first built I don't remember doing anything special. As I attached the joysticks
> and Opti-Pac MAME automatically had them correct.
>
> The very first thing I did was to unplug everything and add them back one-by-one in
> the proper order with the exception of the Opti-Pac which doesn't give you a choice
> as both trackballs are built into the same board. MAME still saw everything in
> reverse order.
>
> Is there a place in MAME where I can reset the controls and tell MAME "Ultrastik #1 =
> player 1", "Optipac trackball 1 = player 1", etc.?
Yes. In your MAME directory, locate the 'config' folder, and delete the file 'default.cfg'. Run MAME and it will recreate 'default.cfg'.
Run MAME again and press the TAB key to bring up the assignment menu. You can set your basic system-wide and UI controls using the 'Input(General)' selection, and any game-specific controls using the 'Input(This Machine)' selection.
|
Index 
Flat 
Re: Mame Controls Reversed
Reply
