> Floating values could be a function of the PCB, tthe quality of the input signal, the > connections, the impedance/capacitance of the probe wire, improper > coupling/grounding...etc. > > If you don't have access to a scope, I'd start by filtering the input pin as shown on > page 7 (below) with a 620 Ohm resistor and a 510pf capacitor to make sure your imput > is clean. > > http://www.national.com/ds/LM/LM1881.pdf
Ok thanks, I'll try filtering the input..but capacitors must be polarized or normal ceramic?
|