MAMEWorld Forums - EmuChat - triforce.c mistake in info

Sorry to be nitpicky but the info is wrong.

Code:

  293        P1         - Motherboard Power Connector (located under the PCB)
  294        P2         - Digital Video Output Connector (not used)
  295        P3         - Controller Pad Board Connector (tied to lower PCB to J8 with a small flat cable)
  296        P4         - Memory Card Slot Connector A  \ (not used)
  297        P5         - Memory Card Slot Connector B  /
  298        P6         - Serial Port Connector 1 (located under the PCB, tied to a plug/cable that leads to J10 on lower PCB)
  299        P7         - Analog Video Output Connector (tied to a plug/cable that leads to J9 on lower PCB)
  300        P8         - Serial Port Connector 2 (located under the PCB, not used)
  301        P9         - Media Port Connector (joins to CN1S on the Media Board)
  302        P10        - Hi-Speed Parallel Port Connector (located under the PCB, not used)

P7 is actually the Digital AV out, P2 is the analogue. While the analogue works fine (Used a standard GC Composite cable), the GC Board is NTSC-J and thus is outputting that system. The Analogue port is also blocked by a metal post.

----
On a quest for Digital 573 and Dancing Stage EuroMix 2

By gods I've found it!