italie |
MAME owes italie many thank yous, hah
|
|
|
Reged: 09/20/03
|
Posts: 15252
|
Loc: BoomTown
|
|
Send PM
|
|
You've all done well.
05/09/14 02:07 PM
|
|
|
> You have two systems, "A" and "B". A drive pulley at "1", and a follower pulley at > "10". Your size ratio will follow the naming convention at 1:10 in both systems. > System "B" is identical to system "A" in all dimensions, with the exception that an > idler pulley was added at "2" and the belt routed around it. > > Please identify the effect the introduction of "2" has on the system, specifically > the effect on "10". You don't have to be specific.
All valid observations from everyone, but Vas had the observation I was waiting for someone to say. Just trying to assess how obvious this should be to the average Joe. Sort of base-lining how ballistic I'm going to go this morning.
(...and Pi, I don't know where you got your engineering degree, but you really know your stuff...)
|
|