> I have a Intervideo/Videocolor monitor (Ref: Dual Frequency Philips A66EAK552X11) and > I had been using a JPAC for a while now with soft 15KHz and quickres without any > problems. Jumper on 15KHz and 35KHz. > > A month or two ago whenever I turned the cab (1 out 5 times perhaps) the image would > be out of sync and I had to regulate the h-sync. It was annoying but I lived with it. > > Now whenever I turn it on the image is out of sync and I can't get it right! The only > significant change I made was connect the remaining 6 buttons I had in my CP to the > JPAC screw connectors. I already tried to disconnect them but I can't get the monitor > to work. > > MOV00719 > > Two photos of the chassis: > > http://www.flickr.com/photos/56737973@N07/5556848345/ > http://www.flickr.com/photos/56737973@N07/5556848605/ > > Help!
If its not a faulty monitor it could be to do with a voltage fault either from the PSU or J-Pac. Check the voltage output using a multi-meter, from the PSU and again from the J-Pac edge connector