|
|
Ok MAME folks, I need your help please!
I d/l coinops Arcade final to rejuvenate my MAME cab and I also swapped PCs so that I could run Win10. I have onboard video but I also have a Nvidia Quadro 4000 card. I've got a Kortek KT-2914F monitor in the cab. It was working fine with the older computer but now I get the 'no signal detected, check signal cable' message on the monitor, probably due to the fact that the refresh rate is too high even though it says 50/60hz on the sticker and I've reduced the resolution to 800x600. I researched a bit online and it seems there's this program called emudriver but it only refers to Radeon cards. How can I get the CRT to be recognized?
Thanks, your help is very much appreciated!
[ATTACHED IMAGE - CLICK FOR FULL SIZE]
|
|
|
B2K24 |
MAME @ 15 kHz Sony Trinitron CRT user
|
|
|
Reged: 10/25/10
|
Posts: 2663
|
|
|
Send PM
|
|
|
Re: CRT help needed please!
[Re: cheg]
#392121 - 10/12/21 09:32 AM
|
|
|
coinops Arcade sounds like crap
Get a Radeon card and use GroovyMAME. The cards can be had cheap for little money and will make your hardware shine once you get everything hooked in correctly
|
|
|
|
Re: CRT help needed please!
[Re: cheg]
#392766 - 12/08/21 11:02 AM
|
|
|
Hook up an old computer monitor if you have one and set it up at the lower resolution first, then power down system and rehook up your arcade monitor and repower the machine.
|
|
|