|
Shift Key in I-PAC
#368523 - 08/03/17 09:35 AM
|
|
|
Hi, i am building an upright arcade cabinet. Now i have finished and i am configuring the I-PAC2 with the Winipac V2 software.
But there is a problem. I dont know how works the "Shift" button in I-PAC.
It's supposed that the Shift key in I-PAC2 is the 1P Start.
And it's supposed too that i can change that Shift key (i dont know how).
Well i configure the 1P SW1 to be the "J" and to be the "u" when Shifted.
For instance, if i press once that key i get back the "J", but when i press 1P Start and the same key, i dont get bak the "u".
How can i make it work?
I am stucked because i need several keys to be shifted.
Thanks in advnace and sorry for my bad english
|
|
|
|
Re: Shift Key in I-PAC
[Re: HHH0178]
#368547 - 08/04/17 03:17 AM
|
|
|
Sounds like you're doing everything correctly.
Check over the webpage & see if you're missing something.
https://www.ultimarc.com/ipac2.html
Make sure the settings are saved to your board after you modify them, and have it load your preference presets on boot too.
Create a new blank text file & mess around with it in there to see if it's working &/or get the hang of it.
|
Pessimist: Oh, this can't get any worse!
Optimist: Yes, it can!
|
|
|
Re: Shift Key in I-PAC
[Re: HHH0178]
#368548 - 08/04/17 03:48 AM
|
|
|
The IPAC supports two full sets of key mappings.
The first set is the normal mapping.
The second set is accessed by holding down the P1 Start button.
So for example, if you push down on the P1 Button 1, it normally sends the key LEFT-CTRL to MAME.
But if you hold down the P1 Start button, and then hit the P1 Button 1, it sends the key "5" to MAME, which adds coins.
By default, only a few of the buttons have shift mappings, but you can map more. The default key mappings are here: http://ultimarc.com/ipac2.html
Do any of the default shift mappings work for you?
|
GroovyMAME support forum on BYOAC
|
|
Previous 
Index 
Next 
Threaded 
Shift Key in I-PAC
Reply
[Re: 
