|
JAMMA - J-PAC - Laptop
#333844 - 10/27/14 03:51 AM
|
|
|
I recently purchased the JPAC to connect to a new JAMMA controller to my Laptop.
I follow all the troubleshoot instruction on the Ultimarc web site with no luck. http://www.ultimarc.com/jpac2.html
The trackball works fine as a direct USB/PS2 connection to the laptop. However, none of the buttons or joysticks function when run through the JPAC.
The drivers installed when the JPAC was connected. And say that they are functioning properly.
All I get is the C9 LED constantly flashing and still no ability to programme the WINIPAC. Says error with drivers.
Any feedback would be appreciated. Sorry if this is a stupid post but I am going in circles.
|
|
|
|
Re: JAMMA - J-PAC - Laptop
[Re: MichaelGreen]
#333930 - 10/29/14 05:37 AM
|
|
|
You sure you're not connecting your laptop to the keyboard pass-through?
|
Scifi frauds. SF illuminates.
_________________
Culture General Contact Unit (Eccentric)
|
|
|
Re: JAMMA - J-PAC - Laptop
[Re: Traso]
#333938 - 10/29/14 11:04 AM
|
|
|
Yes. It is connected to the PC connection and not the KBD.
Worth noting it does the same thing when connected to the KBD connection.
D9 LED (not C9) correction to my above post.
|
|
|
|
Re: JAMMA - J-PAC - Laptop
[Re: MichaelGreen]
#334076 - 11/01/14 12:01 AM
|
|
|
Try un-installing the drivers, refuse when it asks again, and then see.
|
Scifi frauds. SF illuminates.
_________________
Culture General Contact Unit (Eccentric)
|
|