|
Servostik not sending signal until released
#309660 - 06/01/13 09:49 PM
|
|
|
Hi All, I just built a new cab with three servostiks and a Minipac. Two of the joysticks work perfectly. On the other, up, down, and left movements work. However when I move to the right, it doesn't send a signal until I release the joystick. I have confirmed this using words pad. I changed out the joystick with another servo I had and it still does the same thing. Could the Minipac be bad? Any ideas? I am pretty confused. Thanks, David
|
|
|
|
Re: Servostik not sending signal until released
[Re: DavidM]
#309669 - 06/02/13 03:45 AM
|
|
|
for the servostik which is not functioning properly, ensure you have attached the 2 wires to the 'RIGHT' microswitch correctly
if no success, then check to see if the 'RIGHT' microswitch itself is faulty (eg. move the 'RIGHT' microswitch to a different position, and see if the problem also moves...)
|
|
|